5. For customers to maintain the hydraulic system of the hydraulic waste paper baler in time, especially to ensure the cleanliness of the hydraulic oil, to prevent dirt from affecting the life and reliability of the hydraulic system, and to deal with and adjust in time to avoid Cause losses.
4. After the gear pump of the waste paper baler is used for a long time, the relative moving surfaces of the gear will be worn and scratched. The wear of the end face causes the axial gap to increase, the wear of the addendum circle causes the radial gap to increase, and the wear of the tooth profile causes the noise to increase. Therefore, when the abrasion and strain are not serious, it can be used after a little grinding and polishing; if the abrasion and strain are serious, it needs to be repaired or replaced according to the situation.
6. During the blade transportation, you should choose a sturdy wooden box for storage, and wrap the outside with foam plastic to avoid displacement and collision during transportation. The outside of the box should be marked with "vulnerable parts" to attract attention. When unBaler the box in the workshop, use iron tools to pry and smash the wooden box to avoid damaging the cutting edge of the blade.
When the parts work at high temperatures, creep occurs (the stress in the metal is constant, often low stress, but slow and continuous plastic deformation occurs), which will reduce the upper limit of its strength, the upper limit of fatigue, and destroy the normal lubrication conditions.
2. The height adjustment of the box of the automatic waste paper baler is unreasonable. The main performance of this unreasonable is that the height adjustment is too low, and the upper extension part cannot be transported through the cardboard box. At this time, you can push the carton by hand. If there is no push, the height will be higher.