WhatsApp:008615021631102      Email:sales@nkbaler.com       TEL:86-29-86031588

News Center

You Position : Home >> News Center
Maintenance methods of hydraulic balers in the Philippines
Author : admin Time : 2022-09-08 AllPageView : 367
Share:
Today Nick shares with you some maintenance methods about the touch screen of the hydraulic baler.
1. The operator who uses the hydraulic baler must be familiar with the system principle, master the system action sequence and the adjustment method of each component.
2. Before starting the equipment, check whether all motion mechanisms and solenoid valves are in the original state, and check the liquid level in the oil tank. If the oil volume is insufficient, do not start the hydraulic pump.
3. Generally, the oil temperature should be controlled within the range of 35-55 degrees. In winter, when the temperature in the mailbox reaches 25 degrees, it is not allowed to start the sequential actions of the actuators. The heater should be turned on first for heating, or the oil pump should be started to run the pump empty. In summer, when the oil temperature is higher than 60 degrees, cooling measures should be taken, pay close attention to the heating of the system, and stop the pump in time if there is a problem.
4. The hydraulic baler that has been shut down for more than 4 hours should run the pump empty for 5-10 minutes before starting to work, and then work under pressure.
5. Please inject 25 kg of gear oil before starting the machine (one refueling can be used continuously for more than 10 years), and then tighten the plug of the oil filling hole of the hydraulic baler after refueling.
6. Carefully check the power lines to prevent trouble spots and leakage, and ensure safe power usage.
7. Carefully check the machine motor of the hydraulic baler, the bolts and screws of the connecting parts of the transmission parts can be consolidated, and whether there is looseness, so as to be tightened in time.
8. After turning on the machine, idle for 1 minute to check whether the hydraulic baler machine rotates normally. When it is normal, feed a small amount of material, and wait for the remaining material in the machine to be discharged before it can be loaded evenly.
9. Before loading, be sure to pay attention to the hard debris in the raw materials, and prevent stones, iron blocks, etc. from entering the silo to avoid damage to the machine.

10. The oil filling on the universal joint must be refueled once every 8 hours of operation, and 2-3 drops of oil can be filled at a time. Please put a little wet material before shutting down, so that the material can be discharged smoothly after starting the next day.

The above is the maintenance method of the hydraulic baler touch screen shared by NICKBALER. If you encounter problems in the process of using the hydraulic baler, you can always contact us at 86-29-86031588
Shaanxi Nick Machinery Equipment Co.,LTD 
TEL: 86-29-86031588
Fax: 86-29-86031588 Sitemap
Add: East Qunsheng Road Wuxi City,Jiangsu,China
Email:info@nkbaler.com Nickbaler888@gmail.com WhatsApp: 008615021631102  
Copyright © 2018 NKBALER .rights reserved sitemap.html
Whats App Skype Shaanxi Nick Machinery
Equipment Co. LTD
go back to the top