A large amount of rice husk needs to be transported to bio-power plants for power generation.The power supply price of the National Grid is 70 cents per kilowatt-hour,while the cost of using waste rice husks for power generation only needs 3 cents per kilowatt-hour,which is precipitated in the purification and decoking process of rice husk power generation.The ash from the chaff can also be sold as flower fertilizer.
2.Protective motors are suitable for dry and dusty,non-explosive and corrosive gas environments.Under normal circumstances,corn stalk balers can choose this type of motor because of their better ventilation conditions.
4.Check that there is no vibration,vibration and noise damping pipe clamps for the pipes of the waste paper baler.
Because the compressibility of the waste paper baler oil is very small,when the volume of the enclosed space is reduced,the trapped oil is squeezed,the pressure rises sharply,and the oil is forcibly squeezed out from the gap between the joint surfaces of the parts.The gears and bearings are subjected to great radial force;when the waste paper baler gear continues to rotate.This closed volume gradually increases to the maximum position.When the volume increases,it will cause a partial vacuum,separate the gas dissolved in the oil,and generate cavitation,which will cause the gear pump to produce strong noise.This is waste paper.The oil trapping phenomenon of the baler.
The method to eliminate the oil trapping of waste paper baler is usually to mill two unloading grooves on both end covers of the gear pump of waste paper baler.When the closed volume decreases,make it communicate with the oil pressure chamber;and when the closed volume increases When large,make it communicate with the oil suction cavity. The two unloading grooves of general gear pumps are opened asymmetrically.It is often offset to the oil suction cavity,and the distance between the two grooves must ensure that the oil suction cavity and the mooring cavity cannot communicate with each other at any time.
To make the waste paper baler more long-lived and healthy,Nick Machinery recommends that our customers maintain the waste paper baler after work!Focus on checking the hydraulic pump and hydraulic valve of the waste paper baler.Also remember to check once a month and clean the hydraulic oil frequently!
After the autumn harvest,most of the rural straw is not used.The straw forage baler produced by Nick Machinery guillotines and crushes the straw.It uses the straw to answer platinum,compresses it,and then packs it into a bag.It is manually tied and stored outdoors. can.