4.The loss of feed is about 30%,the loss of straw feed is about 15%,and the loss of briquetting is less than 1%,which improves feed utilization and saves feed costs.
5.Convenient feeding of briquette feed,both dry and wet can also be fed,saving labor,effort and time.
1.The installation height,length and diameter of the suction pipe of the oil pump should meet the calculated values,strive to be short and reduce losses (such as elbows, etc.);and ensure that the pump does not exceed its allowable cavitation allowance when it is working.The inner diameter of the oil suction pipe should not be less than the specified requirements.The suction pipe should not be too long.The 90 degree bend should not exceed two.It is connected to the inlet of the oil pump with a soft short connection.The installation height of the oil pump should be such that the hydraulic oil can flow to the suction port of the oil pump.
2.The quality of the oil pump installation has a very important impact on the smooth operation and service life of the pump,so the installation and correction work should be carried out carefully and not rashly.The support or base of the hydraulic pump must be strong and firm,and the pump shaft of the hydraulic pump must be well aligned with the motor.
4.The material reaches the baling standard(the straw machine or kneading machine continues to feed)
This kind of large hydraulic baler is widely used in the green and dry storage of forage grass in animal husbandry.It can save storage space and extend the feeding time of green straw.After packaging and sealing,it will naturally ferment to produce probiotics,beneficial bacteria,lactic acid bacteria,and protein,which will be naturally fermented.Cattle and sheep and other livestock are easily absorbed after feeding,and the growth rate will increase 2%,which greatly reduces the cost of feed transportation and storage,and reduces the labor intensity of workers.It has brought tangible economic benefits to the animal husbandry industry.It is one of the products required for silage reclaiming of medium and large breeding plants.
(2)Adjust the pressure of the waste paper hydraulic baler system to make the pressure display value about 20~26.5Mpa,and tighten the nut.Do several packing sequences in the order of operation.Feed material to the compression chamber.The load test adopts the form of physical packaging.Press 1~2 bales and keep the pressure for 3~5 seconds after the stroke of each waste paper hydraulic baler cylinder is in place.Perform a pressure test on the system and observe if there is any If there is oil leakage,remove it after the system is depressurized.
The two methods mentioned above are the two methods often used by Nick Baler.If you don’t understand during the detection process,please call us:86-29-86031588.