Waste paper baler, so as long as you avoid these problems, you can make the waste paper baler run better.
Generally speaking, every 1000 bales need to be lubricated with engine oil once, but this is easy to absorb dust, so you can choose to lubricate the chains regularly at the end of the season and idle periods, so that the chains are not as easily contaminated as they are running.
Wheel bearings need to be removed, cleaned and replaced every year. When lubricating the wheel bearing, rotate the wheel at the same time, and the common sense of maintenance will stop when the rotation encounters resistance.
Nick Baler automatic horizontal waste paper Baling Press has good heat dissipation, the oil tank has a small heat dissipation area, the oil tank has a small storage capacity, and the oil circulation is too fast.contact us now.
1. Failure analysts should have a strong sense of advancement. With the ability to quickly judge, the problem can be found when the fault is in the initial state, and effective measures can be taken to deal with it to avoid minor faults from forming major faults.
2. The accuracy of the conclusions should be ensured. Only by obtaining very accurate data conclusions can the time and energy used to eliminate faults be reduced, and some common faults of waste paper baler can also be prevented early. Therefore, we should go into the fault analysis of the waste paper baler as much as possible.
Intensity is the basic calculation criterion to measure the working ability of parts of automatic waste paper baler. In order to make the parts work normally, without fracture, excessive residual deformation and fatigue damage during work, the parts must have sufficient strength. The parts of the automatic waste paper baler must meet the strength conditions.
2. Stiffness standard
There are many vibration sources that change over time on the automatic waste paper baler, such as backlash meshing of gears, eccentric rotation of uranium, etc. When the vibration frequency of the fully automatic waste paper baler or parts is similar or equal to the frequency of the periodic interference force, resonance will occur, which is called loss of vibration stability. Resonance not only affects the normal operation of the automatic waste paper baler, but also produces noise, and even causes the destruction of the automatic waste paper baler.
5. Heat resistance standard
2. If the overflow valve in the hydraulic waste paper is deformed, it will seriously affect the main valve core blockage. The main valve core is blocked at the small opening, which will easily cause some of the pressure oil output by the hydraulic waste paper packing machine oil pump to overflow back to the oil tank. The flow of oil in the baler into the actuator is greatly reduced, which slows down the speed of oil supply.
3. The internal and external oil leakage is relatively serious. In rapid work, it is easy to cause the oil supply pressure to be too low, but the pressure is much higher than the oil return oil circuit. When the piston seal of the hydraulic waste paper baler cylinder is damaged, the baler The two sides of the oil cylinder are prone to accidents that cause excessive internal leakage, resulting in insufficient rapid movement of the hydraulic waste paper baler oil cylinder, and other parts are also prone to oil leakage.