Rice husk packing machine is mainly used for compressing and packing wood chips, shavings, rags, peanut husks, rice husks, cotton seeds or other similar loose materials, which greatly reduces transportation costs, saves floor space, and improves work efficiency. What problems will you encounter during use? Nick takes you a brief understanding
1. The machine cannot run: the oil pump motor rotates incorrectly. Exchange any two of the three phase wires until the motor rotates clockwise
2. No hydraulic oil: add hydraulic oil until the best oil level
3. The cylinder can only move in one direction: push the spool with a screwdriver, or remove the valve and clean it.
4. The pressure plate of the Baling Press will not move: the valve coil is burned and check the circuit system with a multimeter. If the wire is ok, please check the coil inside the solenoid valve.
5. Limit switch failure: use a multimeter to detect the limit switch, if it is damaged, replace it directly
6. The maximum weight of the bale cannot be reached. The height of the bale is set too low, and the limit switch can be adjusted to the highest position that can reach the maximum value of the bale. If the maximum weight of the bale cannot be reached, look at the pressure gauge again. It is possible that the pressure setting is lower than the recommended value.

The above are the common faults and solutions of rice husk baler compiled by Nick for everyone. Is it helpful to everyone? For more information about the Baling Press, please pay attention to www.nkbaler.net