The hydraulic baler includes a bracket, the bracket has a bottom plate and front and rear side baffles, a jack is installed on the bracket, the jack has a piston rod, the right end of the piston rod is connected with a vertical pusher plate, and the right side of the pusher plate is connected with a pusher Slats, the gap between adjacent pusher slats is a rope groove on the board; there is an upper baffle on the right part of the bracket, and the bracket on the left side of the upper baffle has a feed inlet; front and rear sides The brackets on the right side of the baffle are respectively fixedly connected with front and rear side barriers, and the gap between adjacent side barriers is a rope threading opening; the right end of the bracket has a discharging port, and the right end of the bracket at the discharging port is hinged with a door panel. Door slats are connected to the left side, and the gap between adjacent door slats is the rope groove on the door; the cavity enclosed by the front and rear side baffle, the pusher plate and the bottom plate is the feed cavity, and the front and rear side baffle bars and pressing materials The cavity enclosed by the upper baffle, the door plate and the bottom plate is a squeezing cavity; the door plate and the right end of the bracket are fixedly connected with a locking device. And the size of the package can be adjusted within a certain range according to needs.
The above is a brief introduction to the structure of the horizontal baler. If you want to know more about the horizontal baler, you can always pay attention to our homepage www.nkbaler.com and more content is waiting for you.