work process
1. Before starting the waste paper baler, check whether the appearance of the equipment is abnormal, whether there are any safety hazards around, whether the iron wire or plastic rope is sufficient. After confirming the normal, open the main air switch of the distribution box, unscrew the emergency stop button, and the power indicator of the electric control box lights up.
2. Remote local gear selection switch to remote control.
3. Put the magnetic switch on the remote control into the card slot and press the system start button on the remote control twice. After the alarm sounds for 10 seconds, stop the warning device to run. The red alarm light is always on.
4. Press the conveyor start button on the remote control, the conveyor belt runs, push the paper or other material into the conveyor inlet, and the conveyor belt brings the material into the packing inlet.
5. After the paper or other material arrives at the position, press the compression button on the remote control, the red alarm light will flash, and the pressure head will automatically retreat and stop after the pressure is in place (if the compression is started, the pressure head will go to a certain position, and it will not stop. After tens of seconds, it will automatically return to the return position. When returning, the siren will alarm at 1 second frequency. At this time, the arm type will be automatically pressed to loosen the arm on the remote control, so that the arm is released, and then the compression is started until normal. Then alarm. Manually report the arm type with the jack on both sides of the arm, the two sides of the screw rotate into some distance, and then start the compression until the normal does not alarm).
6. Repeat 4 operations until the required packing length, press and hold the bale button on the remote control for 2 seconds, the device will start automatically, and the indenter will stop when it advances to the front packing position. After the in-position, the siren will sound at 3 seconds. Call the police.
7. Press the threading button on the remote control, the threading machine will automatically thread the wire or plastic rope, and the threading machine will automatically return to the original position.
8. Cut the wire or rope to a knot and end it.
9. Repeat steps 4-8 above. The bag that is out of the bag will be launched one by one, and the finished bag will be placed in a suitable place by a car or forklift.
10. After the waste paper baler has finished working, press the remote control system stop button, take off the magnetic switch, press the electric control box emergency stop switch, and turn off the main power.