Waste cardboard baler, hydraulic baler, waste paper baler
1. Check the operation status of the pump. If the large and small automatic balers are noisy and the temperature is too high, the pump is likely to be damaged more severely.
2. Master the operation of the pump. Comparing the temperature of the pump body and the fuel tank, if the temperature difference between the two is more than 5℃, the pump can be considered to be more damaged.

3. Check the oil leakage of the pump shaft and the joints, and pay attention to the leakage when the temperature is high and the pressure is high.

4. Observe the sign value of the negative pressure gauge installed at the suction pipe of the pump. When everything is in normal operation, its value should be below 127mmhg; otherwise, check the large and small automatic Baler oil filter and the working oil. A small amount of acetylene gas has been invaded in the oil of the automatic baler, and chemical fiber bubbles can be found in the fuel tank of the car. If a lot of acetylene gas is invaded in the system software, a lot of bubbles will occur in the automobile fuel tank.
At this time, the engine oil is very prone to mildew and cannot be used. In addition, common problems such as vibration, noise, fluctuations in working pressure, instability in the work of construction machinery parts, and destructive commutation caused by moving preforms, and prohibition of positioning, etc. occur in the hydraulic pressure of the automatic baler industrial equipment.
NKBALER recommends that you do a good job of daily maintenance and maintenance of the hydraulic baler, which can effectively extend the service life of the baler. If you want to learn more, please pay attention to www.nkbaler.net