ICKBALER will share with you: How to install and debug the baler? Hope to be of some help to you. The debugging method is as follows:
the first method:
1. After the machine is installed, turn on the power supply of the baler, test the machine with no load, loosen the system overflow valve to make the system overflow squarely, start the motor (the method of stopping after starting), and check the direction of the motor. Can the steering be different from the oil pump sign.
2. Start the motor and check whether the oil pump is stable and reliable during operation. There is no obvious noise in the pump, if not, stop the test machine work.
3. Gradually adjust the relief valve handle of the waste paper hydraulic baler, so that the pressure value is about 8Mpa, and operate according to the operation sequence.
4. Stop single action for each oil cylinder to see if it runs smoothly and without vibration, and gradually adjust the parallelism of the main pressure cylinder and side pressure cylinder with the bottom plate and side frame, fix the main pressure cylinder and side pressure cylinder, and use the adjustment support. The seat supports the rear of the cylinder.
The second method: load test machine
1. It is necessary to adjust the system pressure of the waste paper baler, so that the pressure value is about 20~26.5Mpa, and tighten and tighten the nut.
2. Add material to the feeding port, use the physical packaging method for the load test, press 1~2 blocks, and hold the pressure for 3~5 seconds after the stroke of each waste paper hydraulic baler cylinder is in place, and conduct the pressure resistance test of the system.

Testing the waste paper baler according to the above method can not only check the problems of the waste paper baler, but also solve the problems quickly, so as to ensure the quality of the waste paper baler!

For more common sense of hydraulic baler repair and maintenance, please pay attention to the NICKBALER website https://www.nickbaler.net