1. Adjustment of oil supply system:
1.1. Fuel tank refueling: The rules of this system use hydraulic oil above No. 46. When refueling, pay attention to the refueling pipe not to break the filter screen. The refueling fluid must be pure and clean, and the refueling amount is 800-1000 kg.
1.2. Jog the main pump motor start button to check the direction of the motor. If it does not match the direction of rotation indicated on the pump body, the motor wiring should be interchanged so that the rotation direction is the same.
1.3. Start the oil pump motor for 15 minutes without load, adjust the rising height of each plunger during this period, and then acknowledge the normal and complete the mechanical adjustments of the whole machine to perform the following operations. The metal briquetting machine includes metal chip briquetting machine and metal packing The two models of the machine directly cold press various metal scraps through high pressure, which is convenient for storage, transportation and recycling.
1.4. Price pressure, overflow and adjustment of waste plastic baler:
In order to ensure that the pressure oil entering the main cylinder of the baler can maintain the correct flow and pressure, and to maintain the motor from damage due to overload, it is important to adjust the overflow and unloading.
1.5. Adjust the oil pump pressure:
Step on the materials that need to be packed into the bag box, extend the stepping cylinder to position it, turn on the main oil cylinder and raise the valve. The metal briquetting machine includes two types of metal chip briquetting machine and metal baler. Various metal scraps are directly formed by cold pressing, which is convenient for storage, transportation and recycling. Tighten the oil pump relief valve adjustment knob gradually, pack the load, pay attention to investigate the motor current and pressure gauge readings. When the pressure rises to 20-25Mpa, the valve adjustment knob should be fixed, and after unloading, re-check the package from the beginning.
2. Electrical system debugging:
The primary adjustment of the position of the travel switch, the height of the shaft plug ascending, the waste paper baler is used to knead and firm waste paper and similar products under normal conditions, and package them with special packaging tape to greatly reduce the volume, and then reduce the transportation Volume, saving freight, for the purpose of adding benefits to enterprises. The introduction of advanced technology and advanced technology of similar products at home and abroad.
3. Price trial run of waste plastic baler:
After the above operations are adjusted, you can energize and test the empty car, move the multi-way reversing valve to perform the self-locking actions of the main oil cylinder and the door, and repeat several times to see if it is correct.
The load can be packaged after the various actions of the power-on test and empty car inspection meet the requirements. When the load is packed, the upper limit of the oil pressure gauge should be investigated and adjusted to 20-25Mpa to maintain the motor and pump valve system.
Finally, let's talk about the price of hydraulic baler. Its price depends primarily on its type, use, and market development!
Nick Baler is committed to the production of balers with a complete range of features such as reasonable design, beautiful models, convenient operation, and accurate accuracy. In the future, it will continue to research and innovate to better serve consumers and make consumers more assured.