Before installing the hydraulic system of the
horizontal waste paper baler, you must first prepare various materials, such as: hydraulic system schematic diagram, electrical schematic diagram, system assembly diagram, hydraulic components, auxiliary parts and pipe fittings list and related samples. In order to reduce the occurrence of failures, the hydraulic system of the
horizontal waste paper baler requires high-quality and high-level careful installation.
Some hydraulic components are invaded by sand, dust or rust during transportation or storage, if they are directly installed in the hydraulic system, they may have an adverse effect on the work of the hydraulic system of the
horizontal waste paper baler, and even cause malfunctions. Therefore, the more important components must be tested before installation to check their performance. If any problems are found, they must be disassembled and cleaned, and then reassembled and tested to ensure that the components work reliably. The hydraulic components of the
horizontal waste paper baler are precision machinery. The disassembly, washing and installation of it must be carried out in a clean environment. When disassembling, be familiar with the structure, function and working principle of the disassembled components, and disassemble in order.
When cleaning, it can be cleaned with kerosene, gasoline or oil of the same brand as the hydraulic system. After cleaning, do not wipe with cotton yarn to prevent re-contamination. When assembling the
horizontal waste paper baler, it is forbidden to hit hard, move hard, or screw hard. If there is a drawing, it should be checked with reference to the drawing. In the process of disassembly and washing, the damaged parts, such as the aging seals of the equipment, should be replaced. The reassembled components should be tested for performance and quality.
For systems with oil circuit blocks, check whether the holes on the oil circuit block are connected correctly, and clean the flow channels. In addition, the inside of the oil tank of the horizontal waste paper baler should be cleaned or cleaned. The cleaned hydraulic components should be blocked with plastic plugs when the final assembly is not being carried out, or sealed with tape to prevent the intrusion of dirt.
Here, Nick Machinery recommends that you be fully prepared before installing the hydraulic system of the baler and avoid detours. For more information, please pay attention to www.nkbaler.net