1. String the Baling Machine rope through the automatic tensioning device behind the vertical waste paper baler, and place it along the Baling Machine belt groove, then bundle the Baling Machine belt to the pull-stop at the bottom of the Baling Machine groove, and rotate the automatic elastic tensioning device 90 degrees, Close the bottom door and lock it.
2. Put in the material, when the material is loaded to the height of the platen, close the door tightly and press the "down" button. The equipment runs automatically and compacts. (The feeding height of materials other than cardboard can only be slightly higher than the bottom door).
3. The pressure plate moves down and compresses to the maximum pressure and automatically returns to the fully open position. When compressing the Baling Machine constraints, the platen stops at the preset position of the compressed material.
4. Open the door of the device and pass the tie rope through the bottom wire groove from front to back and back to the front through the pressure plate wire groove. Tighten the tie rope by hand and tie a knot. Push the Baling Machine rod by hand, push the rod to a fixed position, and clamp it tightly. Press the "Up" button, the return stroke of the cylinder will automatically turn out the bundled bundles. (No one is allowed to stand in front of the door when the lower door is opened, so as to avoid accidental injury from the door bounce)

5. After the bale is ejected, reset the bale rod to press down. Finally, the bale is removed, the door is closed and locked for the next bale cycle task.

NKBALER reminds you that in the process of using the waste paper baler, you must strictly follow the product instructions to ensure safe and effective production. If you have other questions, you can go to the website of NKBALER Company https://www.nkbaler.net/.