The cleaning method of the oil pump of the small waste paper baler requires a cleaning process for the hydraulic system when the entire equipment is finished,or when the hydraulic oil needs to be replaced for a long time.The hydraulic system cleaning of small waste paper baler mainly has the following aspects:
1,Clean up the environmental site.
2,Use low-viscosity special cleaning oil, when cleaning,the oil is added to the oil tank of the hydraulic baler and heated to 50-80 degrees Celsius.

3,Launch the hydraulic pump and let it work empty.In the cleaning process,you should often tap the tube gently to remove the attachments.Clean for 20 minutes to check the contamination status of the oil filter,and clean the filter,and then clean,repeat this repeatedly until there are not many contaminants on the filter.Stop.

4,For the messy hydraulic system,each area can be cleaned according to the work area.The hydraulic cylinder can also be connected to allow the hydraulic cylinder to reciprocate for system cleaning.
5,After cleaning the waste paper baler,the cleaning oil must be drained as much as possible,and the inside of the oil tank must be cleaned.Then remove the temporary cleaning circuit to restore the hydraulic baler system to normal operating conditions and participate in the regulation of hydraulic oil.
Nick brand waste paper baler has strong technical force and rich experience.It is a well-known brand in the automatic hydraulic baler industry.