Before operating the straw baler, wear tight-fitting protective clothing, fasten the cuffs, and do not open the hem of the jacket. Do not wear, take off your clothes, or wrap your clothes around the machine to avoid machine damage. You must wear a safety hat, braids should be put in the hat, no skirts, slippers.
Before the straw baler works, start the equipment idling for 3 minutes. At the same time, check whether the oil level of the fuel tank is sufficient, the sound of the oil pump is normal, and whether the hydraulic unit, pipes, joints, and pistons are leaking.
When the bag is turned over, the handle of the cover cylinder is pulled to the return position, and then the handle is pushed in. The surrounding area of ??the package turning board shall be cleared in time every time the package is turned over to prevent jamming.
When the straw baler is baling, the hydraulic operating handle should be quickly pushed to the designated position to prevent valve blockage and insufficient hydraulic oil flow, which may cause motor overcurrent. Every action is in place, the valve handle needs to be restored to the neutral position.
When stopping, close the door cover, then stop the motor and cut off the power supply.

After packing, all hydraulic rods must be retracted into the hydraulic cylinder to prevent dust from damaging the sealing ring and leaking oil.

Regular maintenance work should be done, and if oil leaks are found in the tubing, the center immediately seeks machine repair and disposal.
After the box cover door is opened, it is strictly forbidden to press the door to prevent accidents.
The oil in the tank must be rigorously filtered and always maintain a sufficient amount of oil. The oil tank should be cleaned and changed every six months.
Each smooth part of the equipment should be filled with lubricating oil at least once per shift as required, and the debris in the cavity should be cleared once per shift.
When multiple people operate at the same time, the division of labor should be understood to prevent the risk of misoperation. Those who do not understand the main machine structure, performance and operating procedures are not allowed to start the machine without authorization.
When the straw baler machine shows a serious oil leak or an abnormal phenomenon occurs during work, it should stop immediately. Do not look at the center of the oil radiation, do not directly remove the blockage with your hands, and do not force the operation with disease.
When the straw baler machine is running or packing, it is not allowed to stop repairing or touch the moving parts by hand, and it is strictly forbidden to press materials in the bin with hands or feet.
When the pumps, valves, and pressure gauges are not adjusted, they must be stopped by experienced technicians. If the pressure gauges are found to be defective, they should be repaired or replaced immediately.
The above is the precautions of the straw baler summarized by Nick Machinery. If you have any other questions, please come to our website for consultation www.nkbaler.com.